Trans Tune P0613?

[WYMS]

I just installed a tune that included the Trans tune.

2020 RAM with 68RFE.

Immediately after the tune installation, I got the code P0613 for TCM.

I have not driven a truck yet to do the Trans relearn.

I'm just curious if this has been seen before after your Trans Tune was installed.

It took me about eight tries to clear it.

Finally, it went away and hopefully stays away.

As I said, I have not driven a truck yet.

I will do that late tomorrow.

Thanks.

 0 Comment(s)

[AK Bob]

I have only seen one other case with this code; see the link below, which has the code information attached.

@BLACK5THGEN what was the resolution for this code?

You may also want to check with your tuner to see if they have any suggestions.

Hopefully, others will chime in.

Please keep us posted.

https://www.igotacummins.com/threads...613-Error-Code

 0 Comment(s)

[BLACK5THGEN]

I only had the code pop up twice before the transmission engaged, and I gave throttle reference.

I cleared both times and waited for the transmission to engage before the throttle response.


Sent from my iPhone using Tapatalk

 0 Comment(s)

[WYMS]

Interesting, I had a TCM code about 2 Years ago with this same truck.

Going down the interstate, the cruise was set at 70, and then suddenly, BAM shifts into neutral, and the cruise turns off.

I pulled over (I don't remember the exact code) but cleared it.

I turned the truck off the back and went on my way.

I drove another 800 miles to my destination and had no problems.

It did the exact thing a year later.

It has been two years since it was done.

I haven't had any problems since.

Could this be some stored DTC from that?

Although I would think the tune would have wiped that, I emailed my tuner.

I will see what they say in the meantime.

Thanks

 0 Comment(s)

[WYMS]

I decided to re-install the tune to see if the code popped up again after the upload.

No code after tune install.

So, hopefully, it was just a glitch on the first try.

I drove the truck almost all day today, and everything was good so far.

Thanks

 0 Comment(s)