Thanks: 1
Likes: 9
Have any of yall put a full replacement bumper on your truck, say like a ranch hand at 350 lbs, and had any issues with alignment or fast wear on ball joints etc?
I want to get a replacement but if it causes tire wear and front end issues, I may go to a brush guard.
Jerrod Miller
2018 Ram 3500 CCLB DRW Black, Swapped 68RFE to G56 transmission, Valair DD quiet clutch, DDP grid heater delete, Air Dog Fuel System, Beans Sump.
IGOTACUMMINS thanked for this post
Rough country front bumper.
Not sure of the weight but it’s not a clunker. I was able to install by myself.
These trucks eat ball joints like I eat tacos. Not sure if I could give any good feedback on that part!
Sent from my iPhone using Tapatalk
Ranch hand on all of my trucks.
No issues.
I put a Cattleman pipe bumper @ 265 lbs, and it did sag a bit more in the front but haven’t noticed anything other issues.
I haven’t had it on long though.
Sent from my iPhone using Tapatalk
Posting Permissions
Register To Reply
Bookmarks