MM3 Boost Pressures?

[Josh P]

@Josh P

You might be looking at the alert set point.

You can set alerts, or have it notified you when you exceed a certain number or threshold on parameters.

with boost pressure, I wouldn't add on.

For EGTS, I would for 1400 degrees or so if you wanted to.

Just remember, on a stock MAF Sensor you'll only achieve 37lbs of max boost.

Most will run a separate gauge to monitor true boost pressures that exceed higher pressures.

Is there an aftermarket MAP sensor that can be upgraded?

I’ve been thinking about adding a boost gauge before I came here for help.

 0 Comment(s)

[Corkey]

However, with the MM3, it's a significant pain to get them to function correctly for tuning, which, in the past, has resulted in the stock sensor being left in place.

It's just easier to install a separate gauge for reading higher pressures.

 0 Comment(s)