Does anyone use this map sensor or have any other recommendations besides pillar gauges to read boost levels above 36psi?
Thanks: 7
Likes: 11
Does anyone use this map sensor or have any other recommendations besides pillar gauges to read boost levels above 36psi?
IGOTACUMMINS thanked for this post
What platform are you using, EFI or MM3?
If it's an MM3, getting accurate readings to work properly is a pain and "was "an issue in the past.
Running a mono gauge for higher boost pressure readings is easier and cheaper.
EFI live, depending on the tuner, can run a bigger map bar sensor to display on, say, the CTS3 monitor.
II 60HP STICKS, II 33% CP3, II S464 2ND GEN SWAP, FASS 165 TITANIUM SIGNATURE SERIES, AFE INTAKE HORN, S&B FILTER, 5" TURBO BACK, ALPHAREX HEAD LIGHTS, 38X13.5X20 RAZOR M/T, MOTO METAL RIMS, 6" LA LIFT KIT, COMPLET MM3 KIT, BUILT TRANSMISSION, 6 BOLT REDHEAD STEERING BOX, YUKON 4.56 GEARS W/ COVERS
@Corkey spot on!!!
10bar sensor require rescale; most platforms do not have protocols for adjustments.
I am using EFI Live for my 10-bar and rail sensor mods.
I have seen some doing, but the readings are not accurate scale.
The tuner North of the border has done the best job.
The cheapest is to run a boost fooler kit and use an add-on gauge or Banks with sensors, which have the best data logger.
Banks Power 66760 iDash 1.8 DataMonster
07.5 4x4 Yukon Detroit locker Rear AAM Elect-Front Locker, DOR Front Arm, ATS/Destroke Allison 1000 Conversion W/All 3-Billet Shafts, My Stage-5+ Allison, ATS Five Star TQ Converter, ATS CoPilot, Turbo America Custom VGT, Steed Speed Manifold, (UpGrading Compound Pusher turbo s480 soon) Motorsports Diesel 100% over custom Injectors, MotorSports Diesel 10.6 CP3, AirDog II 165-5G, Rail Pressure Relief 1-Stage, Update Common Rail, Mishimoto Intercooler, ARP 425 Studs, Hamilton Springs,Ret,PR
Posting Permissions
Register To Reply
Bookmarks