2019 3500 DRW.
I am getting a CM bed put on.
I took it to a yard that bought the original bed.
When they took it off, they just unplugged the sensors for the rear camera and park assist so I could reuse them on the new bed.
The guy at the shop doing the installation said you're supposed to go into the computer beforehand and turn all that stuff off, or it might not work again.
It sounds like maybe you can't just plug it back in without getting a service sensor system message all the time.
If this is the case, does it make sense to disconnect the battery to reset the system?
Do I need to reflash?
Can this be handled within the MM3 options?
Or is this just a fluke thing?
Thanks for the help
Sent from my SM-G965U using Tapatalk
Bookmarks