Has Anyone On Here Used Crazy Carls Products?

[C-MAN]

Hi friends, I ordered a tunnel RAM intake plate and an intake horn from Crazy Carls, and the fitment has been a nightmare.

It interferes with the #3 injector line, and when I tried to bend the line out of the way it cracked.

Since I had already messed up my injector line, I tried bolting the horn and grid delete spacer on, and it hit the hood when trying to close it because it is about 2 inches too high.

There were no disclaimers when ordering these parts on their website, and I figured they would be a direct fit, but they are far from it.

Can factory Cummins fuel lines even be bent since I've heard that the p-pump lines are hardened like the common rail lines?

I'm just looking for input from anyone who has purchased these parts and if they've encountered this issue before.

I know 12 valves aren't discussed much on this forum anymore, but any help or advice would be appreciated.

I appreciate any help you can provide.

 0 Comment(s)

[C-MAN]

20241025_065712.jpg

 0 Comment(s)

[C-MAN]

20241121_192754.jpg

 0 Comment(s)

[Corkey]

You can eat dinner off that bad boy.

Toss some ranch in the hole and she'd still probably fire up, LOL.

 0 Comment(s)

[C-MAN]

You can eat dinner off that bad boy.

Toss some ranch in the hole and she'd still probably fire up, LOL.

I laughed way too hard when I read this, Corkey, LMAO.

I wanted this intake setup to work properly, but looks like I might have to find a different plate/horn combo that will clear the line and hood.

I tried it without the grid spacer to try and sneak it under the line, but that didn't work either.

If I'd leave stuff alone and keep it stock I wouldn't have these problems, LOL.

 0 Comment(s)