Before pulling door panel what do you think of pulling BCM fuse? I was thinking they should kill anything stored in the module
Before pulling door panel what do you think of pulling BCM fuse? I was thinking they should kill anything stored in the module
2013 Ram 2500
John 3:16 - Philippians 4:13
See what we are up to on:
FACEBOOK | INSTAGRAM
Or Email me at:
mike@ddpmotorsports.com
www.ddpmotorsports.com
I doubt that will do anything with the way vehicles are now. I would say if you wanted to get the bcm to reset probably try unhooking the batteries and holding the terminals together for a good while. Ide probably tape them together and let it sit half hour or so
Long enough for everything to reset and for the bcm to forget it seen something it didnt like. If its even the case which hopefully it is. this is the way im thinking about it. You take a car that has a misfire to where the pcm shuts fuel off to the cylinder or does whatever it does. And you fix it start it back up without clearing the code. Its gonna more than likely going to still be skipping because it is still in its fail safe mode. So until you clear the code or reset the pcm and it sees everything is normal then it will act normal again if that makes sense? I guess its just something easy to try and dont have to spend any money LOL.
2016 2500 slt. 4x4. 20x10 moto metal 970s on 305-55-20. Fully deleted with mm3. 5 inch tbe.
Understand 100% I was thinking I could pull fuse to isolate the reset to BCM vs whole truck system - I’ll try fuse first
2013 Ram 2500
John 3:16 - Philippians 4:13
See what we are up to on:
FACEBOOK | INSTAGRAM
Or Email me at:
mike@ddpmotorsports.com
www.ddpmotorsports.com
Lemme know it if works. I think itd be awesome if mm3 allowed access to change the programming for the door modules and bcm like basically turn on sales codes and such. Would definately set it apart from everything else even more
2016 2500 slt. 4x4. 20x10 moto metal 970s on 305-55-20. Fully deleted with mm3. 5 inch tbe.
That would be awesome- I would imagine there is some way- they relatively recently added the highbeam with fog feature
2013 Ram 2500
John 3:16 - Philippians 4:13
See what we are up to on:
FACEBOOK | INSTAGRAM
Or Email me at:
mike@ddpmotorsports.com
www.ddpmotorsports.com
Hopefully they are working on it. Esp since they did just do the high and low beams together. Ide love to be able to turn on my lights on my mirrors without paying for a flash at the dealer.
2016 2500 slt. 4x4. 20x10 moto metal 970s on 305-55-20. Fully deleted with mm3. 5 inch tbe.
That or allow running light on mirror with out diode install
uodate- pulled fuse F10 and f24 with no change. Local shop hooked up scanner and showed store code “lost connection with SCM”
still no change.
guess I’ll buy a new door module- online that are about $85
2013 Ram 2500
John 3:16 - Philippians 4:13
See what we are up to on:
FACEBOOK | INSTAGRAM
Or Email me at:
mike@ddpmotorsports.com
www.ddpmotorsports.com
Bookmarks